At what angle are emulsion holes drilled?
3 posts
• Page 1 of 1
At what angle are emulsion holes drilled?
by BradH » Wed Mar 10, 2021 12:02 am
I have a set of metering blocks to work on and am having trouble getting an accurate measurement of the emulsion holes' angle compared to the gasket surface. Anyone happen to know this? Thanks - Brad
- BradH
- Posts: 35
- Joined: Tue Feb 09, 2021 5:52 pm
Re: At what angle are emulsion holes drilled?
by Right hand drive » Wed Mar 10, 2021 6:18 am
If this is the angle you need I am getting 46.5* on a Demon block.
- Right hand drive
- Posts: 334
- Joined: Thu Dec 24, 2020 11:54 am
- Location: Victoria Australia
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests