Starting point calibration for 2 Circuit 1425 Dominator

[jmarkaudio]

Mainwells are opened up, I would run at least .190 to the bottom, and .180 angle. New boosters are not necessary, but the stake tube size also needs to be opened up to around .180. Idle feed at the bottom, start with .040, idle bleed will be between .05 and ,065 depending on engine needs. Main air bleeds .026. Jetting depends on fuel, anywhere from .130-.144.

[Mike Kalbfeld]

Thanks Mark! I really appreciate the advice. I hate to keep prodding you for info, but do you have any suggestions for the emultion package? I was thinking 0.026, blocked, 0.026, blocked and 0.026. I'll incorporate your suggestions and report back.

[bigblockmark]

In case Mark does not see your question, here is what I have seen from him on 2 circuit dominators, but not this big. .026 x .026 x x, or .020 x .020 x .020

[Mike Kalbfeld]

Thanks bigblockmark! I'll give that a try.