Page 1 of 2
Bog when going on the converter
Posted:
Tue Apr 27, 2021 2:33 pmby Banjo
When the air gets good, my car will get a bog getting on the converter. Would this be a contender for the blp sure shot. I have check the accelerator pump, all the passages have been drilled out.
This a 406, with a 1050 dominator.
Link to log pic.
https://flic.kr/p/2kVkQhEThanks in advance
Re: Bog when going on the converter
Posted:
Tue Apr 27, 2021 8:36 pmby hipockets72
Is this a 3 circuit? What emulsion set up?
Re: Bog when going on the converter
Posted:
Tue Apr 27, 2021 9:14 pmby Banjo
This is a two circuit, .024 bleeds on I believe positions 1 and 3, I will have to verify.
Re: Bog when going on the converter
Posted:
Wed Apr 28, 2021 1:05 amby jmarkaudio
What fuel?
Re: Bog when going on the converter
Posted:
Wed Apr 28, 2021 2:29 amby Banjo
Alky, these are also the blocks I got from you some years back.
Re: Bog when going on the converter
Posted:
Mon May 03, 2021 4:47 pmby Banjo
Correction, the bleeds are in positions 1 and 4.
Anyone have any experience with the sure shot?
Re: Bog when going on the converter
Posted:
Tue May 04, 2021 12:20 pmby mike laws
Re: Bog when going on the converter
Posted:
Thu May 06, 2021 12:53 amby mike laws
Re: Bog when going on the converter
Posted:
Sat May 08, 2021 3:35 pmby ojh
Are the carbs 1:1 linkage?
Re: Bog when going on the converter
Posted:
Sat May 08, 2021 4:13 pmby jmarkaudio
Few things with methanol, larger squirter, I have up to a .072 I think, and another is try opening up the mixture screws 1/2 turn more. Smaller idle bleeds or larger idle feeds can be used, and you can also try opening the primary idle speed and taking the idle speed back down with the secondary. This exposes more primary t-slot.